Text 6274, 186 rader
Skriven 2006-06-10 17:58:34 av Maurice Kinal (1:140/13.1)
Ärende: 64-bit ttylinux so far
==============================
Hey All!
Just for fun 'dmesg' from the first 64-bit ttylinux boot kernel;
----- temp.dmesg begins -----
: will probe irqs later
NFORCE-MCP51: 0000:00:0d.0 (rev a1) UDMA133 controller
ide0: BM-DMA at 0xf000-0xf007, BIOS settings: hda:DMA, hdb:DMA
ide1: BM-DMA at 0xf008-0xf00f, BIOS settings: hdc:DMA, hdd:DMA
Probing IDE interface ide0...
hda: M-Systems iDOC V1.01 030804, ATA DISK drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
Probing IDE interface ide1...
Probing IDE interface ide1...
hda: max request size: 128KiB
hda: 128128 sectors (65 MB) w/0KiB Cache, CHS=1001/4/32
hda: cache flushes not supported
hda: hda1
libata version 1.20 loaded.
sata_nv 0000:00:0e.0: version 0.8
ACPI: PCI Interrupt Link [APSI] enabled at IRQ 22
GSI 17 sharing vector 0xD9 and IRQ 17
ACPI: PCI Interrupt 0000:00:0e.0[A] -> Link [APSI] -> GSI 22 (level, low) ->
IRQ 217
PCI: Setting latency timer of device 0000:00:0e.0 to 64
ata1: SATA max UDMA/133 cmd 0x9F0 ctl 0xBF2 bmdma 0xD800 irq 217
ata2: SATA max UDMA/133 cmd 0x970 ctl 0xB72 bmdma 0xD808 irq 217
ata1: SATA link up 1.5 Gbps (SStatus 113)
ata1: dev 0 cfg 49:2f00 82:346b 83:7d01 84:4023 85:3468 86:3c01 87:4023 88:407f
ata1: dev 0 ATA-7, max UDMA/133, 586070255 sectors: LBA48
ata1: dev 0 configured for UDMA/133
scsi0 : sata_nv
ata2: SATA link down (SStatus 0)
scsi1 : sata_nv
Vendor: ATA Model: ST3300831AS Rev: 3.06
Type: Direct-Access ANSI SCSI revision: 05
ACPI: PCI Interrupt Link [APSJ] enabled at IRQ 21
GSI 18 sharing vector 0xE1 and IRQ 18
ACPI: PCI Interrupt 0000:00:0f.0[A] -> Link [APSJ] -> GSI 21 (level, low) ->
IRQ 225
PCI: Setting latency timer of device 0000:00:0f.0 to 64
ata3: SATA max UDMA/133 cmd 0x9E0 ctl 0xBE2 bmdma 0xC400 irq 225
ata4: SATA max UDMA/133 cmd 0x960 ctl 0xB62 bmdma 0xC408 irq 225
ata3: SATA link down (SStatus 0)
scsi2 : sata_nv
ata4: SATA link down (SStatus 0)
scsi3 : sata_nv
SCSI device sda: 586070255 512-byte hdwr sectors (300068 MB)
sda: Write Protect is off
sda: Mode Sense: 00 3a 00 00
SCSI device sda: drive cache: write back
SCSI device sda: 586070255 512-byte hdwr sectors (300068 MB)
sda: Write Protect is off
sda: Mode Sense: 00 3a 00 00
SCSI device sda: drive cache: write back
sda: sda1 sda2 sda3 sda4
sd 0:0:0:0: Attached scsi disk sda
sd 0:0:0:0: Attached scsi generic sg0 type 0
Fusion MPT base driver 3.03.07
Copyright (c) 1999-2005 LSI Logic Corporation
Fusion MPT SPI Host driver 3.03.07
ACPI: PCI Interrupt Link [APC3] enabled at IRQ 18
GSI 19 sharing vector 0xE9 and IRQ 19
ACPI: PCI Interrupt 0000:01:0e.0[A] -> Link [APC3] -> GSI 18 (level, low) ->
IRQ 233
ohci1394: fw-host0: OHCI-1394 1.1 (PCI): IRQ=[233] MMIO=[f5004000-f50047ff]
Max Packet=[2048] IR/IT contexts=[4/8]
ieee1394: raw1394: /dev/raw1394 device initialized
ACPI: PCI Interrupt Link [APCL] enabled at IRQ 20
GSI 20 sharing vector 0x32 and IRQ 20
ACPI: PCI Interrupt 0000:00:0b.1[B] -> Link [APCL] -> GSI 20 (level, low) ->
IRQ 50
PCI: Setting latency timer of device 0000:00:0b.1 to 64
ehci_hcd 0000:00:0b.1: EHCI Host Controller
ehci_hcd 0000:00:0b.1: debug port 1
PCI: cache line size of 64 is not supported by device 0000:00:0b.1
ehci_hcd 0000:00:0b.1: new USB bus registered, assigned bus number 1
ehci_hcd 0000:00:0b.1: irq 50, io mem 0xf5104000
ehci_hcd 0000:00:0b.1: USB 2.0 started, EHCI 1.00, driver 10 Dec 2004
usb usb1: configuration #1 chosen from 1 choice
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 8 ports detected
ohci_hcd: 2005 April 22 USB 1.1 'Open' Host Controller (OHCI) Driver (PCI)
ACPI: PCI Interrupt Link [APCF] enabled at IRQ 23
ACPI: PCI Interrupt 0000:00:0b.0[A] -> Link [APCF] -> GSI 23 (level, low) ->
IRQ 209
PCI: Setting latency timer of device 0000:00:0b.0 to 64
ohci_hcd 0000:00:0b.0: OHCI Host Controller
ohci_hcd 0000:00:0b.0: new USB bus registered, assigned bus number 2
ohci_hcd 0000:00:0b.0: irq 209, io mem 0xf5108000
usb usb2: configuration #1 chosen from 1 choice
hub 2-0:1.0: USB hub found
hub 2-0:1.0: 8 ports detected
USB Universal Host Controller Interface driver v2.3
Initializing USB Mass Storage driver...
usb 1-5: new high speed USB device using ehci_hcd and address 2
usb 1-5: configuration #1 chosen from 1 choice
ohci_hcd 0000:00:0b.0: wakeup
scsi4 : SCSI emulation for USB Mass Storage devices
usbcore: registered new driver usb-storage
USB Mass Storage support registered.
usb-storage: device found at 2
usb-storage: waiting for device to settle before scanning
mice: PS/2 mouse device common for all mice
input: AT Translated Set 2 keyboard as /class/input/input0
input: PC Speaker as /class/input/input1
i2c /dev entries driver
device-mapper: 4.5.0-ioctl (2005-10-04) initialised: dm-devel@redhat.com
oprofile: using NMI interrupt.
NET: Registered protocol family 2
IP route cache hash table entries: 32768 (order: 6, 262144 bytes)
TCP established hash table entries: 131072 (order: 9, 2097152 bytes)
TCP bind hash table entries: 65536 (order: 8, 1048576 bytes)
TCP: Hash tables configured (established 131072 bind 65536)
TCP reno registered
TCP bic registered
NET: Registered protocol family 1
NET: Registered protocol family 10
IPv6 over IPv4 tunneling driver
NET: Registered protocol family 17
powernow-k8: Power state transitions not supported
ACPI wakeup devices:
HUB0 XVRA XVRB XVRC USB0 USB2 AZAD MMAC MMCI UAR1
ACPI: (supports S0 S1 S4 S5)
RAMDISK: Compressed image found at block 0
VFS: Mounted root (ext2 filesystem) readonly.
Freeing unused kernel memory: 212k freed
usb 2-6: new full speed USB device using ohci_hcd and address 2
ieee1394: Host added: ID:BUS[0-00:1023] GUID[0016e60000b29f96]
usb 2-6: configuration #1 chosen from 1 choice
scsi5 : SCSI emulation for USB Mass Storage devices
usb-storage: device found at 2
usb-storage: waiting for device to settle before scanning
Vendor: Generic Model: USB SD Reader Rev: 1.00
Type: Direct-Access ANSI SCSI revision: 00
sd 4:0:0:0: Attached scsi removable disk sdb
sd 4:0:0:0: Attached scsi generic sg1 type 0
Vendor: Generic Model: USB CF Reader Rev: 1.01
Type: Direct-Access ANSI SCSI revision: 00
SCSI device sdc: 503808 512-byte hdwr sectors (258 MB)
sdc: Write Protect is off
sdc: Mode Sense: 03 00 00 00
sdc: assuming drive cache: write through
SCSI device sdc: 503808 512-byte hdwr sectors (258 MB)
sdc: Write Protect is off
sdc: Mode Sense: 03 00 00 00
sdc: assuming drive cache: write through
sdc: sdc1
sd 4:0:0:1: Attached scsi removable disk sdc
sd 4:0:0:1: Attached scsi generic sg2 type 0
Vendor: Generic Model: USB SM Reader Rev: 1.02
Type: Direct-Access ANSI SCSI revision: 00
sd 4:0:0:2: Attached scsi removable disk sdd
sd 4:0:0:2: Attached scsi generic sg3 type 0
Vendor: Generic Model: USB MS Reader Rev: 1.03
Type: Direct-Access ANSI SCSI revision: 00
sd 4:0:0:3: Attached scsi removable disk sde
sd 4:0:0:3: Attached scsi generic sg4 type 0
usb-storage: device scan complete
Vendor: LEXAR Model: JUMPDRIVE Rev: 1.20
Type: Direct-Access ANSI SCSI revision: 01 CCS
SCSI device sdf: 251904 512-byte hdwr sectors (129 MB)
sdf: Write Protect is off
sdf: Mode Sense: 23 00 00 00
sdf: assuming drive cache: write through
SCSI device sdf: 251904 512-byte hdwr sectors (129 MB)
sdf: Write Protect is off
sdf: Mode Sense: 23 00 00 00
sdf: assuming drive cache: write through
sdf: sdf1 sdf2
sd 5:0:0:0: Attached scsi removable disk sdf
sd 5:0:0:0: Attached scsi generic sg5 type 0
usb-storage: device scan complete
eth0: no IPv6 routers present
kjournald starting. Commit interval 5 seconds
EXT3 FS on sda4, internal journal
EXT3-fs: recovery complete.
EXT3-fs: mounted filesystem with ordered data mode.
EXT2-fs warning: mounting unchecked fs, running e2fsck is recommended
----- temp.dmesg ends -----
Life is good,
Maurice
--- Msged/LNX 6.2.0
* Origin: The Pointy Stick Society XVIII - Don't know what I want (1:140/13.1)
|