Text 929, 59 rader
Skriven 2007-02-15 18:02:00 av Lorderos (650.dove-nix)
Ärende: digi camera /etc/fstab
==============================
I'm trying to access my digital camera via USB, but with no luck.
scsii support is loaded in the kernel
hotplug starts at boot time.
$lsusb reports camera information
$dmesg reports that the camera is on sda1, and reports when I shut it off.
below is the output of $dmesg

usb.c: registered new driver usbdevfs
usb.c: registered new driver hub
uhci.c: USB Universal Host Controller Interface driver v1.1
PCI: Found IRQ 11 for device 00:07.2
PCI: Sharing IRQ 11 with 00:11.0
uhci.c: USB UHCI at I/O 0xe000, IRQ 11
usb.c: new USB bus registered, assigned bus number 1
hub.c: USB hub found
hub.c: 2 ports detected
hub.c: new USB device 00:07.2-1, assigned address 2
usb.c: USB device 2 (vend/prod 0x54c/0x10) is not claimed by any active driver.
Initializing USB Mass Storage driver...
usb.c: registered new driver usb-storage
scsi1 : SCSI emulation for USB Mass Storage devices
  Vendor: Sony      Model: Sony DSC          Rev: 2.10
  Type:   Direct-Access                      ANSI SCSI revision: 02
Attached scsi removable disk sda at scsi1, channel 0, id 0, lun 0
SCSI device sda: 63424 512-byte hdwr sectors (32 MB)
sda: Write Protect is off
 sda: sda1
WARNING: USB Mass Storage data integrity not assured
USB Mass Storage device found at 2
USB Mass Storage support registered.
UMSDOS 0.86k (compatibility level 0.4, fast msdos)
UMSDOS 0.86k (compatibility level 0.4, fast msdos)
uhci.c: e000: host controller halted. very bad
usb.c: USB disconnect on device 00:07.2-1 address 2

Should I be mounting the device? I set up a directory in /mnt/camera
things I have tried but didn't work within /etc/fstab

/dev/sda1   /mnt/camera  auto          noauto,owner  0   0
/dev/sda1   /mnt/camera  usbdevfs      defaults      0   0

and various combinations of the above.
I'm not sure if I am totaly off base or what?
If different information is needed I will gladly supply it.
For now I can just use my wifes windows machine and xfer the files to my pc,
but since everything looks like it should work there is no reason that I
can't just use this machine. Any Help would be greatly appreciated.
I _have_ googled for info on this, but the solutions they give seem like work
I don't have to do, since the machine is recognizing the camera, it's just that
I don't know how to access it, and I am doing it all as root.
TIA

*Lord Eros*


---
 þ Synchronet þ Vertrauen þ Home of Synchronet þ telnet://vert.synchro.net
--- SBBSecho 2.12-Win32
 * Origin: Joe's Computer & BBS -= joesbbs.synchro.net =- (1:275/412)